Elation 1400E Manuale Utente Scaricare il pdf (Pagina 26)

a new show while one is running it will replace the current show. If you select a new scene while a show is

running it will also turn off the show. If at any time you need to see the show display for a show that is

running you can restore it by pressing the “show” switch.

If you are using the automatic timer to run the show, press the left arrow switch to pause the timer and the

right arrow switch to continue. Press the right arrow switch to advance a show to the next step if the show

is not paused. You can also press the “go” switch to call the next show step, even when not in manual

mode. This gives you the option of manually overriding the show timer by turning off the clock with the

left arrow switch and then manually stepping the show using the “go” switch. You can turn the clock back

on at any time by pressing the right arrow switch. If the show was recorded for manual mode the clock

cannot be turned on.

If the show is set to loop, it will play continuously restarting after the last step’s hold time has counted

down to 0 or if you press “go” during the last step. If loop is set to “off”, the show will end after the last

scene has been called. If there is a link programmed with the show, the linked show will start as soon as the

last step’s hold time has elapsed or after the go switch is pressed in manual mode following the last step.

ERASE SHOW

To erase an existing show, press “record” then “show” then “erase”. As when recording a show, all LEDs

that contain a show will be lit. Next select the show to erase. That show name will appear in the LCD. The

message “Erase this Show?” will also appear. Press “yes” or “no”. If you press “yes” the show will be

erased. Erase show only works when there is no show currently being edited. While editing a show, “erase”

is used to erase show steps. You can abort show erase at any time by either pressing “no” or by exiting

record mode by pressing the “record” switch.

Note: It can take up to 30 seconds to overwrite or erase a show depending on how much of the memory is

currently filled.

EDITING SHOWS

To edit a show that has already been recorded, press “record” followed by “show”. Instead of entering

steps for a new show, press the show number of the one you want to edit. The message “Edit this existing

Show?” will appear in the display. Press “yes” and the show will be called up and you can add to it or

modify it by selecting steps and changing any value. You can use the erase switch to remove a step. You

can also insert additional steps by pressing “add”. You will be prompted whether or not to add an empty

show step here. Press “yes” to insert an empty show step at the current step number. All following show

steps will be moved up one number. After the empty step is added you can record a scene or time value

there.

After editing, a show can be saved at the same or at a new location by pressing any number switch. You

can use this method to copy a show to another memory location by calling it for edit and then saving it

without making any changes. Please note that the “scene” LED must be turned off before you can save the

show.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Nessun commento

Elation 1400E Manuale Utente Pagina 26