Elation 1400E Manuale Utente Scaricare il pdf (Pagina 33)

MEMORY RESTORE USING THE COMPUTER PORT

To copy a memory file from your PC back to Show Designer 2, first go to the menu selection in Show

Designer 2 labeled “load memory file from COM port”. Press “enter” and the display will read, “Waiting

for file from COM port”. Show Designer 2 is now ready to receive the file from your PC.

If you are using SD Backup, follow the instructions for “Send File”. If using Hyper Terminal, call the

version of Hyper Terminal that you created for Show Designer 2. Click on “Transfer” on the top menu bar

and select “Send Text File”. A dialog box will appear allowing you to select the Show Designer text file

that you made when you backed up. Find the drive and folder where you created the file if it is not in the

current window, select the file and click on “Open”. Hyper Terminal will begin to transmit the file. The

Show Designer 2 display will read “receiving file”. After the file has been sent, Show Designer 2 will restart

and show its startup display. If any errors have been detected, Show Designer 2 will prompt you to retry.

Check your connections and try again. The length of time it takes to update the memory will vary

depending on the amount of memory in use at the time it was recorded.

UPDATING THE SOFTWARE

The software that runs Show Designer 2 can be updated with new versions available from the Elation

Lighting web site at www.elationlighting.com. New software updates will include things such as new

features. You can also download updated versions of this manual that will describe any new features.

To copy the new software file from your PC to Show Designer 2, go to the Show Designer 2 menu

selection labeled “update software”. Press “enter” and the display will read, “download new program”.

Show Designer 2 is now ready to receive the file from your PC. As an alternative you can access this menu

by holding down the “menu” and “erase” switch while powering up Show Designer 2.

If you are using SD Backup, follow the instructions for “Send File”. If you are using Hyper Terminal, call

the version of Hyper Terminal that you created for Show Designer 2. Click on “Transfer” on the top menu

bar and select “Send Text File”. A dialog box will appear allowing you to select the text file that you

downloaded from the web site. Make sure that the file has been unzipped before trying to use it (the file

will end with .txt not .zip). Find the drive and folder where the file is located, select the file and click on

“Open”. Hyper Terminal will begin to transmit the file. The Show Designer 2 display will read, “receiving

new program”. After the file has been sent, Show Designer 2 will restart and show its startup display. If any

errors have been detected, Show Designer 2 will prompt you to retry. Check your connections and try

again. It will take several minutes to transfer the file.

Software updates must be done from a floppy disk if you have the disk drive option installed.

LOAD FIXTURE PROFILE

You must use the SD Backup program to send a fixture profile to the Show Designer 2 using your PC.

Hyper Terminal will not work for this. On the SD2, go to the menu item “Load fixture profile from COM

port”. The message “Ready to receive fixture profile, press enter to cancel” will appear on the display. Use

the “Send File” function on the SD Backup program to send a fixture profile to the Show Designer 2. The

Show Designer 2 will wait indefinitely until you send the file or until you press the “enter” switch to cancel.

1 2 ... 28 29 30 31 32 33 34

Nessun commento

Elation 1400E Manuale Utente Pagina 33